To Make Automatic Measurements - Teledyne T3DSO2000 Series User Manual

To Make Automatic Measurements

Perform the steps below and select voltage or time parameters to make automatic
measurements.
1. Press the Measure button on the front panel to enter the MEASURE function menu.
2. Press the Source softkey, and then use the Universal Knob to select the desired
channel. Only analog channels (CH1~4) that are displayed are available for
measurements.
3. To select and display measurement parameters. Press the Type softkey, and then
turn the Universal Knob to select the desired measurement parameter.
4. Press the Universal Knob to add the measurement parameter, the parameters and
value will be shown above the menu, and the statistics status will update.
5. To turn off the statistics function, press the Statistics softkey to select Off.
The measurement display area can display 5 measurement parameters at most, and the
measurements will arrange according to the selection order. If a fifth measurement
parameter is added, the first measurement will be deleted.
1.800.561.8187
140
Figure 78: Select the Measurement Parameter
www. .com
information@itm.com