Uart/Rs232 Trigger And Serial Decode; Setup For Uart/Rs232 Signals - Teledyne T3DSO2000 Series User Manual

UART/RS232 Trigger and Serial Decode

The following section describes trigger and decoding for UART/RS232 bus types and
is organized as follows: 'Setup for UART/RS232 Signals", "UART/RS232 Triggering'
And 'UART/RS232 Decode'.

Setup for UART/RS232 Signals

1. Press the Decode key to enter the DECODE function menu.
2. Press the Decode softkey and select the desired decoder (Decode1 or Decode2).
3. Press Protocol softkey and then select UART by turning Universal Knob.
4. Press Signal softkey to enter the SIGNAL menu as Figure 47 shows.
5. Set RX:
1)
2)
6. Set TX:
a.
b.
7. Press the Bit Order softkey to select the bit order(LSB or MSB).
8. Press
9. Press the Configure softkey to enter BUS CONFIG menu.
1.800.561.8187
94
Figure 47: UART SIGNAL Menu
Press RX to select the channel that is connected to the RX signal.
Press first Threshold key to set the RX signal threshold voltage level by
Universal Knob. The threshold voltage level is for decoding, and it will be
regarded as the trigger voltage level when the trigger type is set to serial.
Press TX to select the channel that is connected to the TX signal.
Press first Threshold key to set the TX signal threshold voltage level by
Universal Knob. The threshold voltage level is for decoding, and it will be
regarded as the trigger voltage level when the trigger type is set to serial.
softkey to return previous menu.
www.
information@itm.com
.com