To Set The Lan - Teledyne T3DSO2000 Series User Manual

To Set the LAN

Do the following steps to set the oscilloscope to communicate with a PC via LAN:
1. Connect the oscilloscope to your local area network using the network cable.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the I/O Set softkey to enter the I/O SET function menu.
4. Press the LAN softkey to enter the LAN setting interface, see the picture below:
5. Press the F1 softkey (the first softkey below the screen) continually to go to the DHCP
line; then turn the Universal Knob to select Enable or Disable.
�
�
6.
1.800.561.8187
168
Figure 94: LAN Setting Interface
Enable: The DHCP server in the current network will assign the network
parameters (such as the IP address) for the oscilloscope.
Disable: Set the IP address, subnet mask, and gate way manually.
�
Turn the Universal Knob to select the desired value.
� Push the Universal Knob to change item horizontally.
�
Press the F1 softkey to go to the next line.
�
Press the Save/Recall softkey to save the current setting.
�
Press the Single button to exit the setting interface.
Use NI-MAX to communicate with the oscilloscope.
www.
information@itm.com
.com