To Update Firmware And Configuration - Teledyne T3DSO2000 Series User Manual

To Update Firmware and Configuration

The firmware and configuration can be updated directly via the USB flash drive.
Do the following steps to update the firmware:
1. Insert the USB flash drive containing the firmware and the configure files into the USB
host interface on the front panel of the oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Firmware softkey and it will pop-out the message "Press 'Single' to
continue and press 'Run/Stop' to exit!"
7. Press the Single button to enter the SAVE/RECALL file system.
8. Turn the Universal Knob to select the update file which should be with an ADS postfix;
and then press the Load softkey to start the firmware update. The process takes about
7 minutes. And during the update, do not turn off the oscilloscope, otherwise the
oscilloscope will not restart again.
9. After finishing the update, the screen will display the message "Update success,
please restart the DSO", and the oscilloscope will output a buzzing sound.
10. Restart the oscilloscope to finish the firmware update.
Do the following steps to update the configuration:
1. Insert the USB flash drive containing the firmware and the configure files into the USB
host interface on the front panel of the oscilloscope.
2. Press the Utility button on the front panel to enter the UTILITY function menu.
3. Press the Next Page softkey to go to the second page of the UTILITY function menu.
4. Press the Next Page softkey to go to the third page of the UTILITY function menu.
5. Press the Update softkey to enter the UPDATE function menu.
6. Press the Configure softkey to enter the SAVE/RECALL file system.
7. Turn the Universal Knob to select the update file which should be with an CFG
postfix; and then press the Load softkey to start update the firmware. The process
takes about 30 seconds.
8. After finishing the update, the screen will pop-out the message "Update success,
please restart the DSO", and the oscilloscope will output a buzzing sound.
9. Restart the oscilloscope to finish the configuration update.
1.800.561.8187
171
www. .com
information@itm.com