The Rear Panel - Teledyne T3DSO2000 Series User Manual

The Rear Panel

1. Handle
Pull up the handle vertically for easy carrying of the instrument. When you do not need
the handle, press it down.
2. LAN
The instrument can be connected to a user-network via this interface to perform
remote control.
3. USB Device
The T3DSO2000-series support SCPI remote control commands. User can control the
oscilloscope through this interface.
4. Pass/Fail or Trigger Out
This connector outputs either a Pass/Fail pulse when using this mode of operation or it
can be used to output a pulse that corresponds to each oscilloscope trigger operation.
5. External Trigger terminal
6. Safety lock Hole
This hole is designed to accommodate a Kensington style of lock (user-supplied).
7. AC Power Socket
AC power input terminal. The power requirements of this oscilloscope are 100-240 V,
50/60 Hz or 100-120 V, 400 Hz. Use the power cord provided with the instrument to
connect it to AC power.
1.800.561.8187
Figure 7: Rear panel Overview
www. .com
information@itm.com
11