To Set Display Type - Teledyne T3DSO2000 Series User Manual

To Set Display Type

Press the Display button on the front panel, and then press the Type softkey to select
Vectors or Dots display type.
�
Vectors: the sample points are connected by lines and displayed. Normally, this
mode can provide the most vivid waveform to view the steep edge of the waveform
(such as square waveform).
�
Dots: display the sample points directly. You can directly view each sample point and
use the cursor to measure the X and Y values of the sample point.
1.800.561.8187
144
Figure 81: Vectors Display
Figure 82: Dots Display
www. .com
information@itm.com