Vertical - Teledyne T3DSO2000 Series User Manual

Vertical

again to turn it off.
at the lower part of the screen will change accordingly. Press the knob to quickly reset the
offset to zero.
and the scale message at the right side of the screen will also change. Press the knob to
quickly switch the vertical scale adjustment modes between "Coarse" and "Fine".
1.800.561.8187
Analog input channels. The four channels are marked by different colors which
are also used to mark both the waveforms on the screen and the channel input
connectors. Press channel button to open the corresponding channel and press
Vertical Position Knob: Set the vertical offset of the current waveform. Turn
clockwise to increase the position and turn counterclockwise to decrease. When
changing the offset, the waveform will move up and down and the offset message
Vertical Scale Knob: Sets the vertical scale of the current waveform. Turn
clockwise to decrease the scale value and while turn counterclockwise to increase
it. During the modification, the 'amplitude' of the waveform will enlarge or reduce
www.
information@itm.com
.com
13