To Save and Recall Test Mask
Users can save the current test mask to the internal Flash memory or external USB flash
device. The file format of the test mask file is '*.RGU'.
��
Save Test Mask to Internal Memory
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the Next Page softkey to go to the second page of the UTILITY function
3. Press the Pass/Fail softkey to enter the PASS/FAIL function menu.
4. Press the Enable Test softkey to select On to enable the pass/ fail test.
5. Press the Source softkey to select the desired channel.
6. Press the Mask Setting softkey to enter the MASK function menu.
7. Press the X Mask or Y Mask softkey; and then turn the Universal Knob to select
8. Press the Location softkey to select Internal
9. Press the Save softkey to save the mask to internal memory.
10. A few seconds later, it will pop-up the message 'Store Data Success!'
��
Recall Test Mask from Internal Memory
1. Press the Utility button on the front panel to enter the UTILITY function menu.
2. Press the Next Page softkey to go to the second page of the UTILITY function
3. Press the Pass/Fail softkey to enter the PASS/FAIL function menu.
4. Press the Enable Test softkey to select On to enable the pass/ fail test.
5. Press the Mask Setting softkey to enter the MASK function menu.
6. Press the Location softkey to select Internal.
7. Press the Load softkey to recall the saved interval memory.
8. A few seconds later, it will pop-out the message 'Read Data Success!' and the
1.800.561.8187
menu.
the desired value.
Note: The internal memory can only save one test mask; saving a new test mask
will replace the previous one.
menu.
saved mask will be displayed on the screen.
www.
information@itm.com
.com
165