To Set Output Load; Recover The Default Setup Of Awg - Teledyne T3DSO2000 Series User Manual

To Set Output Load

11. Press the Wave Gen button on the front panel to enter the WAVEFORM function
menu.
12. Press the Setting softkey to enter the SETTING function menu.
13. Press the Output Load softkey to select High-Z or 50Ω.
The output load of the Wave Gen must match with the oscilloscope, or the amplitude of
the signal will be incorrect.

Recover the Default Setup of AWG.

1. Press the Wave Gen button on the front panel to enter the WAVEFORM function
menu.
2. Press the Setting softkey to enter the SETTING function menu.
3. Press the Default softkey to recover the default values of Wave Gen (Sine, 1.000 KHz,
4.000Vpp, 0.0mVdc).
1.800.561.8187
Figure 105: SETTING Function Menu
www. .com
information@itm.com
184