Figure 3.35 Network Information Setting Window (Dhcp Disabled); Table 3.31 Network Information Setting Items - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 3 Remote Panel Operation
3.11 Setting Library Information

Figure 3.35 Network information setting window (DHCP disabled)

2
Set each of the following items:

Table 3.31 Network information setting items

Setting item
Enable IPv4
Enable DHCP
IP Address
Subnet Mask
Gateway
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Specify whether the IP address setting in IPv4 format is enabled or disabled.
At least one of the settings for IPv4 or IPv6 must be enabled.
When the IP address setting in IPv4 format is disabled, the settings related to IPv4
are also disabled.
Specify whether the DHCP is enabled or disabled.
When the DHCP is enabled, all fields other than the NTP Server field are
automatically set and cannot be entered.
Enter the IP address of the LT270 S2 in IPv4 format.
Only numeric characters can be entered.
Enter the subnet mask of the LT270 S2.
Only numeric characters can be entered.
This item needs to be set if accessed from outside SUB-LAN or accessed from the
browser via a proxy server inside SUB-LAN.
Only numeric characters can be entered.
116
Copyright 2020 FUJITSU LIMITED
Explanation
P3AM-6932-06ENZ0