Table of Contents
Advertisement
Chapter 3 Remote Panel Operation
3.10 Setting Target ID of the Drive
2
Make settings for each item.
Table 3.28 Drive information setting items
Setting item
Topology
Addressing Mode
LOOP ID
Drive Link Speed
3
Click the [OK] button after all settings are completed. To restore the conditions before the
settings, click the [Reset] button.
4
After clicking the [OK] button, the system displays a confirmation window showing the
input contents. Click the [OK] button if it is OK to proceed. To make entries again, click the
[Back] button.
5
If processing is completed, the system displays a window showing the processing results.
This completes the settings.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Select from "Fabric" or "FC_AL".
This item is enabled if "FC_AL" is selected in Topology.
Select from "Hard" and "Soft."
This item needs to be specified if "Hard" is set as the Addressing Mode.
Select LOOP ID.
Specify the Link Speed settings of the drive. ("1Gbps", "2Gbps", "4Gbps", "8Gbps",
or " Auto")
110
Copyright 2020 FUJITSU LIMITED
Explanation
End of procedure
P3AM-6932-06ENZ0
Advertisement
Table of Contents
