Table of Contents
Advertisement
Chapter 3 Remote Panel Operation
3.12 Operating the Library
4
Select the load destination drive. Select a target cabinet from the drop-down list to display a
list of drives for the selected cabinet.
5
Click the [OK] button and then a confirmation window is displayed.
Select the [OK] button if it is OK to proceed. If the number of selected tape cartridges differs
from the number of drives, an error message appears in a pop-up window.
6
A message indicating that the process is in progress is displayed. A separate window
(showing the progress of processing) displays the number of cleaning drives in which to
load cartridges and the number of drives in which cartridges have been loaded.
7
Loading into the selected drive is complete when an end message is displayed.
3.12.5
Ejecting Tape Cartridges
This section explains how to eject tape cartridges that are loaded in drives to their home cells.
When an eject operation is performed, the drive goes offline temporarily. When the eject operation is
complete, the drive automatically returns online.
Cartridges can be ejected from the following drives:
•
Drives containing cartridges from a CAS
•
Drives containing cartridges from the host
•
Normally, the tape cartridges from which data has been successfully backed up are ejected to their home
cells by the backup software. However, if host control is disabled for reasons such that a host closed
down, the tape cartridges must be ejected manually.
•
If ejection is attempted while the backup software is accessing the library, a message is displayed stating
that the library is busy. Retry the ejection when the library is no longer busy.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
146
Copyright 2020 FUJITSU LIMITED
End of procedure
P3AM-6932-06ENZ0
Advertisement
Table of Contents
