Figure 2.23 Ipv6 Network Setup Window (1/2) - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 2 Operator Panel Operation
2.7 Library Information Setup
2.7.1.2 IPv6 Network Settings
The following section describes how to set up an IPv6 network:
Procedure
1
Click the [Network] button from the Setup menu, and then click "IPv6".
SETUP menu
-Network
2
Click the list button, and then select "Enable" for IPv6.
3
Click the list button, and then select "Auto" or "Manual" for INPUT.
When "Manual" is selected to input values manually, use the numeric keypad buttons to enter the
values for Link Local Address, Global Address, Length of Subnet Prefix, Gateway, and NTP Server
Address (if required).
The window to enter these values consists of two pages. To switch between the pages, press the [Next]
button or the [Back] button.
After inputting the values in all of the required fields, click the [Next] button on the second page.

Figure 2.23 IPv6 network setup window (1/2)

FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
+IPv6
Copyright 2020 FUJITSU LIMITED
46
P3AM-6932-06ENZ0