Chapter 3 Remote Panel Operation
3.10 Setting Target ID of the Drive
3.10
Setting Target ID of the Drive
This section explains the settings for interface when connecting a drive to the host.
Procedure
1
Click the [Drive] button displayed under [Setup] in the menu frame. A window for drive
settings will be displayed. If the drive settings are already made, its values are displayed.
Figure 3.31 Drive setup window
•
If there are tape cartridges in the drives and there is no drive that can be set, the message "All
drives are initializing, powered off or holding cartridges." is displayed.
•
Only drives that can be set are displayed in the window. For drives that cannot be set, the current
value is displayed.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
109
Copyright 2020 FUJITSU LIMITED
P3AM-6932-06ENZ0