Setting Library Information; Setting Information About The Host Interface; Figure 3.32 Adapter Selection Window - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 3 Remote Panel Operation

3.11 Setting Library Information

3.11 Setting Library Information
3.11.1

Setting Information about the Host Interface

The following explains the settings for the interface Target ID and security for connecting the LT270 S2 to the
host.
Procedure
1
Click the [Host I/F] button displayed under [Setup] in the menu frame. A window for
selecting the adapter will be displayed. Select the adapter to be set and then click the [OK]
button.

Figure 3.32 Adapter selection window

• If there is no adapter that can be set due, for example, to adapter errors, the message "No adapter
card installed." is displayed.
• Only adapters that can be set are displayed in the window.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
111
Copyright 2020 FUJITSU LIMITED P3AM-6932-06ENZ0