Table of Contents
Advertisement
Chapter 3 Remote Panel Operation
3.7 E-mail Setup Information
Table 3.23 E-mail setup information
Display item
Recipient address (To)
Sender address (From)
SMTP server (IP address)
SMTP port
Send E-mail
The following shows an example of e-mail contents to be sent when a library error occurs.
Table 3.24 E-mail contents that are sent when a library hardware error occurs
***The Library error occurred.***
Timestamp : 2004/8/1 12:00:00
IP Address : 192.168.1.2
FSC : 20001001
FRU : PCA LCNT UNIT
Sense Key : 04
ASC/ASCQ : 4400
Barcode Label : LTO281L1
Host ID : 01
Target ID : 125
Logical Unit Number : 00
Command code : a5
Source Address : 1000
Destination Address : 500
Library Serial Number : 0001
Overall Library : 01-01
Boot Loader Version : R1_1_0-050701
Library Control Firmware : R1_1_0-050701
Library Control Hardware : Board:0/FPGA:4
Library Servo Firmware : V00L05
Library Servo Hardware : Board:0/FPGA:1
Overall Drive Module 00 : 01-01
Drive 00 Firmware : 53Y2
Overall Drive Module 01 : 01-01
Drive 01 Firmware : 53Y2
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Displays destination addresses (up to five addresses).
Displays the source address.
Displays the IP address of the SMTP server.
Displays the port number of the SMTP server.
Displays whether to send e-mail.
•
Enable: Send e-mail.
•
Disable: Do not send e-mail
Indicates the time at which an error occurred.
Indicates the IP address. (The device name is displayed if it is
set.)
Indicates the Fault Symptom Code.
Indicates the replacement parts.
Indicates the Sense key.
Indicates ASC/ASCQ.
Indicates the barcode label used when an error occurred.
Indicates LOOP ID of the host or switch.
Indicates LOOP ID of the library.
Indicates the Logical Unit number of the library.
Indicates the SCSI command when an error occurred.
Indicates the source cell address.
Indicates the destination cell address.
Indicates the serial number of the library.
Indicates the total version number of the controller.
Indicates the firmware version number of the boot loader.
Indicates the firmware version number of the controller.
Indicates the hardware version number of the controller.
Indicates the firmware version number of the servo unit.
Indicates the hardware version number of the servo unit.
Indicates the total version number of the drive module 00.
Indicates the firmware version number of the drive unit 00.
Indicates the total version number of the drive module 01.
Indicates the firmware version number of the drive unit 01.
104
Copyright 2020 FUJITSU LIMITED
Explanation
Explanation
P3AM-6932-06ENZ0
Advertisement
Table of Contents
