Figure 2.22 Ipv4 Network Setup Window - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 2 Operator Panel Operation
2.7 Library Information Setup
To use these functions, network information must be set up. The network information settings are available
with both IPv4 and IPv6.
The following sections describe how to set up the network information:
2.7.1.1 IPv4 Network Settings
The following section describes how to set up an IPv4 network:
Procedure
1
Click the [Network] button from the Setup menu, and then click "IPv4".
SETUP menu
-Network
2
Click the list button, and then select "Enable" for IPv4.
3
Click the list button, and then select "Disable" or "Enable" for DHCP.
When "Disable" is selected to disable DHCP, use the numeric keypad buttons to enter the values of IP
Address, Subnet Mask, Gateway, and NTP Server Address (if necessary).
After making the entries, click the [Next] button.

Figure 2.22 IPv4 network setup window

4
A confirmation window is displayed.
Click the [OK] button if it is OK to proceed.
5
A message indicating that the process is in progress is displayed. The Setup menu is
displayed again when the setting is complete normally.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
+IPv4
Copyright 2020 FUJITSU LIMITED
45
End of procedure
P3AM-6932-06ENZ0