Table of Contents
Advertisement
Chapter 3 Remote Panel Operation
3.11 Setting Library Information
2
Set each item:
Table 3.33 E-mail setting items
Display item
Recipient address
(To)
Sender address
(From)
SMTP server
(IP address or Domain
Name)
SMTP Port
Enable Send E-mail
If any character that is not allowed is entered, an input error message is displayed.
3
Click the [OK] button after all settings are completed. To restore the conditions before the
settings, click the [Reset] button.
4
When the [OK] button is clicked, a confirmation window is displayed.
Click the [OK] button if it is OK to proceed. To make entries again, click the [Back] button.
5
If processing is completed, the system displays a window showing the processing results.
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Up to 5 e-mail addresses from which notification should be received can be
registered. Up to 64 characters can be entered in the text area. Characters that can
be entered are alphanumeric characters and symbols (- _ . @). To remove a mail
address already set from the Recipient address, delete the relevant mail address.
Set as the source mail address an address registered in the IP address of the SMTP
server to be set in the next item. Up to 64 characters can be entered in the text area.
Characters that can be entered are alphanumeric characters and symbols (- _ . @).
Set the IP address of the SMTP server used for sending e-mail.
The IPv4 address, the IPv6 address, and the domain name can be specified.
Set the port of the e-mail server used to send e-mail (normally 25). Up to five
characters can be entered in a text area. Only numeric characters ranging from 1 to
65535 can be entered in one text area.
Specify whether to send e-mail to the address specified above if an error occurs.
Select this item to enable sending. Clear this item to disable sending.
121
Copyright 2020 FUJITSU LIMITED
Explanation
End of procedure
P3AM-6932-06ENZ0
Advertisement
Table of Contents
