Chapter 3 Remote Panel Operation
3.12 Operating the Library
3.12.6
Releasing a Hardware Error of the Drive
This section explains how to perform a recovery operation to release hardware errors that occur in drives.
•
During recovery of a drive error, only that drive remains off-line. The backup software cannot access the
drive until the recovery operation is complete.
•
If recovery of a drive error is attempted while the backup software is accessing the library, a message is
displayed stating that the library is busy. Retry the recovery when the library is no longer busy.
If a hardware error of the drive occurs, "error code" is displayed in the Status window.
Procedure
1
Click the [Drive Reset] button displayed under [Operation]. The following window is
displayed.
Figure 3.58 Drive reset window
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
148
Copyright 2020 FUJITSU LIMITED
P3AM-6932-06ENZ0