Figure 2.41 Selecting The Operator Mode; Figure 2.42 Drive Status When The Operator Mode Is Disabled - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 2 Operator Panel Operation
2.17 Setting Up the Operator Account
2
Set Operator Mode to Enable (the default is Disable), click the [Next] button and then click
the [OK] button.

Figure 2.41 Selecting the operator mode

The following figures show the drive status when the operator mode is enabled and disabled.
■ When Operator Mode is Disabled
For general users: The [CAS Open] button and reference information are available for use.

Figure 2.42 Drive status when the operator mode is disabled

69
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Copyright 2020 FUJITSU LIMITED P3AM-6932-06ENZ0