GE LOGIQ E9 Service Manual page 75

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Remove the OP panel foam placed

between the monitor and probe holders.

Remove the lower OP panel brace placed

between the lower OP panel and the

wooden ramp, by moving upward and back.

Remove the wooden ramp.

Attach the wooden ramp to the Pallet Base

with Velcro on the rear side of the

10. Loosen the tie-down strap at the front of the

LOGIQ E9. Push the brass piece to pull

back handle, then push brass piece to

loosen strap.

Uncrating Instructions (Continued)

Chapter 3 LOGIQ E9 Setup

Corresponding Graphic