GE LOGIQ E9 Service Manual page 395

GE
D 5535208-100, R
IRECTION
8-5-8-2 Probe Connectors Label Placement
1. Remove the adhesive from the new Label
and place it above the Probe Connector
openings, as shown.
If replacing the Label only, remove the old
Label completely.
8-5-8-3 Plate Connectors w/Guide installation
1. Position the plate and snap it into position.
2. Install the Front Cover, Foot Rest Bumper, Top Cover and the Side Covers.
. 2
EV
Table 8-33 Probe Connectors Label Placement
Steps
Table 8-34 Plate Connectors w/Guide installation
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
ERVICE
Corresponding Graphic
Corresponding Graphic
M
ANUAL
5328860
8 - 49