GE LOGIQ E9 Service Manual page 370

GE
D 5535208-100, R
IRECTION
8-4-6-13 Functional Checks
Perform the following functional checks to confirm the system is operational before returning the system
to the customer.
If all are successful, include the following debrief script: LOGIQ E9 Service Manual, Direction
5535208-100, Rev. 2. Equipment passed all required checks and is ready for use.
See:
Section
4-2-2
4-2-3
4-3-14
4-3-5
4-3-7
4-3-18
4-3-10
8-4-7 Loading the Application Software Only
Use this procedure to update application software only.
1.) Place the LOGIQ E9 Application Software DVD in the CD/DVD Drive, while the system is running.
2.) Reboot the system. The Start Application window displays.
Figure 8-14 Start Application window (window will reflect actual software version
3.) Select "Install SW." Press OK on the Start Loader message and then press OK on the New System
Software message. A Command window similar to the example shown in
Window" on page 8-25
8 - 24
. 2
EV
Table 8-1 Loading the Software Functional Checks
Functional Check
Power ON/Boot Up
Power shut down
Probe/Connectors Checks
B-Mode Checks
System CFM and PWD Checks
Mechanical Function Checks
Basic Measurements
instead of "Rx.x.x")
opens.
Section 8-4 - Loading / Reloading / Upgrading the Software
Debrief Script
LOGIQ E9 Service Manual, Direction
5535208-100, Rev. 2. Equipment passed all
required checks and is ready for use.
LOGIQ E9 S M
ERVICE ANUAL
Figure 8-15 "Command