GE LOGIQ E9 Service Manual page 184

GE
D 5535208-100, R
IRECTION
4-3-10-2 Check Circumference/Area (Ellipse) Measurement
1.) Press Measure once to display an active caliper.
2.) Move the Trackball to position the active caliper.
3.) Press Set to fix the start point.
4.) The system fixes the first caliper and displays a second active caliper.
5.) Move the Trackball to position the second caliper.
6.) Turn the Ellipse control; an ellipse with an initial circle shape appears.
NOTE: Be careful not to press the Ellipse control as this activates the Body Pattern.
7.) Move the Trackball to position the ellipse and to size the measured axes (the calipers).
8.) To increase the size, turn the Ellipse control in a clockwise direction. To decrease the size, turn the
Ellipse control in a counterclockwise direction.
9.) To toggle between active calipers, press Measure.
10.)Press Set to complete the measurement.
11.)The system displays the circumference and area in the measurement results window.
NOTE: Before you complete a measurement:
• To erase the ellipse and the current data measured, press Clear once. The original caliper is
displayed to restart the measurement.
• To exit the measurement function without completing the measurement, press Clear again.
4-3-10-3 Worksheets
Measurement/Calculation worksheets are available to display and edit measurements and calculations.
There are generic worksheets as well as Application specific worksheets. The worksheets are selected
from the Measurement Touch Panel.
4-3-10-4 Report Pages
Measurements/Calculations that are included on the worksheet can also be displayed on Report Pages.
Report Pages can be customized to meet the appropriate needs of the user.
4 - 40
. 2
EV
Section 4-3 - Functional checks
LOGIQ E9 S M
ERVICE ANUAL