GE LOGIQ E9 Service Manual page 351

GE
D 5535208-100, R
IRECTION
8-2-5 Tools needed for servicing the LOGIQ E9
In addition to the standard tools listed in
following tools (TORX bits or drivers) are needed to service the LOGIQ E9. If the torque is not indicated
with the procedure, hand tighten the screws/nuts.
Table 8-1
TOOL TYPE
FLAT BLADE
SCREWDRIVER
PHILLIPS
SCREWDRIVER
HEX KEY
OPEN END WRENCH
TORQUE WRENCH
ADJUSTABLE
WRENCH
PRY BAR
* 90 degree "L" is suggested. A full set of 90 degree "L" Torx wrenches are
recommended.
** Heavy mechanical parts may need a specific torque. Each procedure will
indicate the torque needed.
. 2
EV
Tools used for servicing LOGIQ E9
TORX
approximately 18 inches overall (457 mm)
Chapter 8 Replacement procedures
10-4-2 ""Standard" GE Tool Kit in the USA" on page
TOOL SIZE
BIT # TX-10
BIT # TX-15
BIT # TX-20
BIT # TX-25
BIT # TX-30*
BIT # Tx-45*
1/4 inch or 6 mm
PH1
PH2
PH3
5 mm
8 mm
10 mm
5 mm
10 mm
13 mm
3/16 inch
Up to 81 Nm (59.7 lbf-ft)**
152 mm (6 inches) long
LOGIQ E9 S M
ERVICE ANUAL
10-4, the
8 - 5