GE LOGIQ E9 Service Manual page 377

GE
D 5535208-100, R
IRECTION
8-5-2-1 Side Covers removal
NOTE: Whenever the left Side Cover is removed, clear the BEP Fan(s) intake(s) of any debris.
When removing or installing the right side cover on a LOGIQ E9 with the On-board V Nav Stand, the
cover is removed and installed in the same manner, except the rear portion of the cover must be placed
behind the stand.
Table 8-4
1.
NOTE: The removal procedure is easier if
the rear lock is released first, and then the
front lock.
The Side Covers are "clicked" on to the
LOGIQ E9 with two locks, located at the
lower end of the cover.
1a. Push a #1 phillips screwdriver into the
rectangular hole in the Side Bumper until it
reaches the lock mechanism.
1b. Push the handle on the screwdriver
downwards to release the lock.
2.
Lift the cover backwards and up to remove
it from the system. Repeat steps for the
opposite side.
Set cover in a safe place.
. 2
EV
Side Covers removal
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
LOGIQ E9 with Covers and
Side Cover removed
M
ERVICE ANUAL
8 - 31