GE LOGIQ E9 Service Manual page 467

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

V2 LCD Arm Assembly Adapter installation

Insert the Adapter into the Frame UI Upper

Align the mounting holes and install the two

M5 x 50 hex key screws using a 4 mm Hex

Key to secure the Adapter. Torque 2.5 Nm

(1.8 lbf-ft {21.6 lbf-in}).

NOTE: Note the shape of the rear

mounting hole, this is important for the

next step before the Thrust Plate is

NOTE: MAKE SURE the rear mounting

hole for the Arm Neck Lock Pin, in the Trust

Plate is aligned with the rear mounting hole

of the Adapter BEFORE installing the

Plate. If the Plate is installed incorrectly, it

may be very difficult to remove.

Align the rear mounting hole for the Arm

Neck Lock Pin, in the Trust Plate with the

rear mounting hole of the Adapter.

Seat the Plate. The plate will be captured

by the two retaining pins that protrude from

the Adapter.

Install the Ground Cable to the LCD

Adapter and to the Bulkhead using the two

screws and lock washers. Torque 1.3 Nm

(0.96 lbf-ft {11.5 lbf-in}).

Re-install the LCD and Arm Assembly and connect the LCD Cable.

V2 Arm Adapter installation

Chapter 8 Replacement procedures

Corresponding Graphic

LCD Ground Cable installed