GE LOGIQ E9 Service Manual page 661

GE
D 5535208-100, R
IRECTION
8-12-6-1 Calibration and adjustments
No calibrations or adjustments are needed after this part replacement.
8-12-6-2 Verification
Perform the following steps to verify that the product is functioning as intended after this replacement:
1.) Connect cables and Probes you removed earlier
2.) Power up the LOGIQ E9 to verify that it operates as intended.
8-12-6-3 Functional Checks
Perform the following functional checks to confirm the LOGIQ E9 is operational before returning the
LOGIQ E9 to the customer.
If all are successful, include the following debrief script: LOGIQ E9 Service Manual, Direction
5535208-100, Rev. 2. Equipment passed all required checks and is ready for use.
NOTE: Be sure to inform the customer that the On-Board V Nav Stand SHOULD NOT be used to push
the LOGIQ E9.
See:
Section
4-2-2
4-2-3
4-3-18
4-3-18-2
. 2
EV
Table 8-195 Side Covers replacement Functional Checks
Functional Check
Power ON/Boot Up
Power shut down
Mechanical Function Checks
Brakes and Direction Lock Checks
Chapter 8 Replacement procedures
Debrief Script
LOGIQ E9 Service Manual, Direction
5535208-100, Rev. 2. Equipment passed all
required checks and is ready for use.
LOGIQ E9 S M
ERVICE ANUAL
8 - 315