GE LOGIQ E9 Service Manual page 548

GE
D 5535208-100, R
IRECTION
Table 8-122 BEP removal - R3.x and earlier
4.
Remove the two 5 mm HEX key screws at
the inside base of the BEP.
5. Reach inside the BEP to disconnect the
BEP to Backplane cable from J3 on a GFI
Configuration.
Release the lock connector for the BEP to
Backplane cable, J2 (left) on a MRX
Configuration. Keep the cable to transfer to
the replacement BEP.
6.
Slide:
• the entire BEP away from the system approximately one inch, then finish removing the Printer
Tray.
• the entire BEP out of chassis and remove the BEP from the system.
8 - 202
. 2
EV
Steps
Section 8-9 - BEP (Back End Processor) parts replacement
LOGIQ E9 S
Corresponding Graphic
BEP Base HEX key screws
BEP Cable to Backplane J3 of GFI Configuration
(views inside the BEP)
BEP Cable to Backplane, J2 (left) of
MRX Configuration
M
ERVICE ANUAL