GE LOGIQ E9 Service Manual page 413

GE
D 5535208-100, R
IRECTION
8-5-15 LCD Monitor V2 Arm Assembly Covers replacement (cont'd)
Table 8-45
1.
Pan Arm Down Cover (1), remove two
Phillips screws and lift the cover off.
Lift Arm Cover - Right (2) and Lift Arm
Cover - Left (3), remove the 3 mm screws
and slide the Cover toward the Monitor.
Joint Cover (4), slightly push the bottom of
the Cover forward to "bow" the cover and
pry at the leading, forward edge of the
Cover to remove.
Extension Arm Cover (5), remove the
3 mm screw and lower cover.
Install covers in the reverse motion. To
install the Joint Cover, place top of Cover
into position and snap into place.
. 2
EV
LCD Monitor V2 Arm Assembly Covers removal and installation - R5.x and later
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
2
1
3
M
ERVICE ANUAL
4
5
8 - 67