GE LOGIQ E9 Service Manual page 569

GE
D 5535208-100, R
IRECTION
Table 8-135 BEP Side I/O Board removal
5.
Remove the four Phillips screws securing
the Side I/O Board to the BEP frame.
6.
Slowly and carefully pull the I/O Board out
of the BEP, making sure to avoid hitting
components and circuit pins on both sides
of the Board. Pay attention to the
installation guide pins and the slots in the
bracket that need to be clear as I/O Board
and bracket are removed.
7.
Set the I/O Board aside.
. 2
EV
Steps
Chapter 8 Replacement procedures
LOGIQ E9 S
Corresponding Graphic
I/O Board installation guides and slots
M
ERVICE ANUAL
8 - 223