GE LOGIQ E9 Service Manual page 547

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

BEP replacement - R3.x and earlier (cont'd)

BEP removal - R3.x and earlier

Table 8-122 BEP removal - R3.x and earlier

When you return the used BEP to your local parts organization, make sure you remove ALL

PATIENT DATA from the Hard Drive, given that the Hard Drive is still functional.

In some countries, you may be required to delete all software from the disk before returning the

BEP to the parts warehouse. Follow your local policies.

Before you dispose of the Hard Drive, make sure you remove ALL PATIENT DATA from the Hard

Drive, given that the Hard Drive is still functional.

In some countries, you may be required to delete all software from the disk before returning the

Hard Drive to the parts warehouse. Follow your local policies.

When the BEP door is open, the Extended Power Shutdown circuit board is exposed. When

working inside the BEP, remove the battery cable form J3 on the Extended Power Shutdown.

Otherwise, the 24V battery will be exposed. If you drop a tool or a screw on the Extended Power

Shutdown, you could short the battery. Permanent damage will be done if this happens.

NOTE: Some cables in the BEP have a locking latch. Make sure to slide the locking latch towards you

and pull the connector to the left to release.

Disconnect all I/O cables and all cables at the top of the BEP.

Loosen the thumb screw or screws at the top of the BEP cover that attach the cover to the BEP.

Tilt the top of the BEP cover away from the BEP.

• the battery cable from J3 on the EPS

(Extended Power Shutdown) Board.

• the cables (1) connecting the EPS to the

Place the BEP cover aside.

Chapter 8 Replacement procedures

Corresponding Graphic

inside of BEP Cover, EPS and cables