GE LOGIQ E9 Service Manual page 435

GE
D 5535208-100, R
IRECTION
8-6-2 LCD Monitor assembly replacement (cont'd)
NOTE: New labels have been added to the LCD rear cover to meet the IEC 60601-1 compliance
requirements. When replacing the LCD Monitor on a LOGIQ E9 console, make sure that if the
LCD back cover labels are on the console, the labels are on the replacement FRU. This will
ensure there is no confusion between the labels on the console and the labels described in the
User and Service Documentation.
Table 8-55
Console is third edition
compliant:
labels ARE ON the LCD Monitor
Cover
Console is pre-third edition
compliant and the new labels
ARE NOT on the LCD Monitor
Cover.
8-6-2-1 LCD Monitor removal - R3.x and earlier
A cover at the rear side of the LCD Monitor assembly covers the two cables to the monitor. To get
access to the cable connectors, remove the Cable Cover.
Table 8-56
1. For easy access, tilt the LCD Monitor
forward to horizontal position.
Unscrew the fixing screw on the rear side of
the LCD Monitor assembly.
Remove the Monitor Cables Cover.
Lift the cover away and place it in a safe
place.
. 2
EV
LCD Rear Cover Labels
Console
FRU DOES NOT have the new
labels on the LCD Cover.
FRU HAS the new labels on the
LCD Monitor Cover.
LCD Monitor removal - R3.x and earlier
Steps
Chapter 8 Replacement procedures
FRU
The original VESA cover with
new labels should be used on the
replacement Monitor to maintain
compliance of the console.
The original VESA cover on the
console should be used on the
replacement LCD Monitor. The
new labels ARE NOT described
in the User and Service
Documentation.
Corresponding Graphic
Monitor Cables Cover Screw and
Monitor tilted forward
LOGIQ E9 S M
ERVICE ANUAL
Action
8 - 89