GE LOGIQ E9 Service Manual page 117

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Print button actions can also be modified per model (abdomen, etc.) by settings in

Utility -> Application -> Print Controls. Inspect them when print button behavior differs from

Print Button Settings

Print buttons use the same formats as Compression on the Image Storage

NOTE: Suppose compression is specified on both a print button and on

an image storage service, either assigned to the button or assigned to the

dataflow in use. Also, suppose the compression settings are different. At

the point the is to send an image generated by the print button to the

service, the will first un-compress the compressed version of the print

button, and then recompress it using the settings of the service. If the

compression of the print button is lossy, the un-compression will not

completely restore the original image. Then applying the compression of

the service still generates a lossy image. The process of un-compressing

and recompressing only has a negative impact on system performance.

In general then, DO NOT use compression on a print key if images it

generates end up getting sent to a service; or, IF YOU DO, use the exact

same compression on the service.

Chapter 3 LOGIQ E9 Setup