GE LOGIQ E9 Service Manual page 478

GE
D 5535208-100, R
IRECTION
Table 8-87
4. Remove the four screws with washers from
the rear of the console.
5. NOTE: Make sure the five OP Panel Knobs
have been removed.
Lift the Upper OP Panel/Touch Panel
assembly slightly from the bottom, and then
tilt the top toward the front of the system.
There are tabs at the bottom of the Touch
Panel Assembly. Pull straight up on these
tabs.
NOTE: For better access, swing the LCD
Monitor to the side.
6. Disconnect the cables at the back of the Upper OP Panel/Touch Panel Assembly (see:
Figure 8-42 "Upper OP Panel/Touch Panel assembly cable placement - R4 and earlier" on page
8-133).
8 - 132
. 2
EV
Upper OP Panel/Touch Panel Assembly removal
Steps
Section 8-6 - Replacing Top Console Parts
LOGIQ E9 S
Corresponding Graphic
Back Cover of the Upper OP Panel/Touch
Panel Assembly, Screws and Washers
Removing the Upper OP Panel/Touch
Panel Assembly
M
ERVICE ANUAL