GE LOGIQ E9 Service Manual page 550

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

BEP installation - R3.x and earlier

Table 8-123 BEP installation - R3.x and earlier

Reinstall the following parts from the BEP that was replaced (all that were present):

• Flex Jumper Cable

• SATA cable (which goes between the DVR and Motherboard)

• Patient I/O filler

• Patient I/O module

• Option Dongle

• Printer Tray

Slide the BEP into the left side of the chassis frame.

Install the two HEX key screws at the inside

base of the BEP (Torque: 10 Nm

{7.4 lbf-ft}).

Section 8-9 - BEP (Back End Processor) parts replacement

Corresponding Graphic