GE LOGIQ E9 Service Manual page 531

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Removal Process with Non-loop Type Strap (cont'd)

Tilting the system is NOT a recommended method for the removal of the filter. The

bottom view in Figure 8-64 is only for illustrative purposes.

8-7-3-2-1Cleaning the bottom filter

The bottom filter is held in place with magnets. To clean the bottom air filter,

1.) You need to kneel down on the floor to access the bottom filter. Locate the piece of cloth extending

from the air filter on the bottom of the LOGIQ E9.

2.) You need two hands to remove this filter. One hand is used to pull on the piece of cloth that extends

from the filter and the other hand is used to wedge a finger just under a corner of the filter. In this

step, firmly take hold of the piece of cloth that extends from the filter.

3.) Position your other hand at a corner of the filter and wedge a finger between the filter and the bottom

of the LOGIQ E9.

4.) Pull down on the filter with the finger that is wedged between the filter and the LOGIQ E9 while

pulling on the piece of cloth that extends from the filter at the same time to remove the filter.

5.) Clean this filter with soap and water, or vacuum clean.

6.) Reposition the filter at the bottom of the LOGIQ E9.

Figure 8-64 Bottom View for Removing the Filter

Chapter 8 Replacement procedures