GE LOGIQ E9 Service Manual page 445

GE
D 5535208-100, R
IRECTION
8-6-2-6 LCD Monitor V2 installation - R5.x and later
Table 8-61
1.
WHEN INSTALLING THE LCD TO THE
ARM, KEEP THE LCD ARM ASSEMBLY
IN THE LOCKED POSITION. THE
SPRINGS TO SUPPORT THE LCD CAN
CAUSE THE ARM TO SPRING OPEN
CAUSING SEVERE PERSONAL INJURY
AND PROPERTY DAMAGE.
2.
Reinstall the upper two Phillips into the
Monitor.
With the Monitor flat, slide the Monitor onto
the Arm Assembly. The Monitor will be
supported by the two upper screws.
Reinstall the two lower Phillips screws (1)
and tighten the upper Phillips screws (2).
Make sure the Monitor is level before
tightening the screws securely.
3.
The LCD Cable to LCD is secured to the
LCD with a retaining screw (1), an EMC
shielded retainer (2) and two phillips
screws (3).
Remove the screws and retainer, if present
or re-install the Cable into LCD and tighten
the screw (1).
Install the retainer and secure with the two
M4X12 screws (3).
. 2
EV
LCD Monitor V2 installation - R5.x and later
Steps
WARNING WARNING
Chapter 8 Replacement procedures
LOGIQ E9 S
ERVICE
Corresponding Graphic
M
ANUAL
8 - 99