GE LOGIQ E9 Service Manual page 389

GE
D 5535208-100, R
IRECTION
8-5-6 Foot Rest Bumper replacement
Manpower /
Time
One person /
15 minutes
Table 8-21
1. Power down the system.
2. Disconnect the mains power cable from the wall outlet and all Probes and External I/O Cabling.
Preparation Link (if you need more information):
4-2-3 "Power shut down" on page 4-7.
8-5-6-1 Foot Rest Bumper removal
NOTE: In Table
to remove the Side Cover to perform this procedure.
The Foot Rest Bumper is fixed with snap locks.
1.. Pull the Foot Rest Bumper upwards and
over the pedals to release the snap locks,
while freeing the side latches.
You may need to push down the pedals to
be able to remove the Foot Rest Bumper.
. 2
EV
Table 8-20 Manpower / Time and Tools
Preparations and Preparation Link
Preparations - you must perform the following steps
8-22, the Side Cover was removed to be able to view the Side Latch. You do not need
Table 8-22 Side Latch for Foot Rest Bumper
Steps
Chapter 8 Replacement procedures
Tools
No additional tools required.
LOGIQ E9 S
ERVICE
Corresponding Graphic
M
ANUAL
8 - 43