GE LOGIQ E9 Service Manual page 506

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5535208-100, R

Lower Operator Panel installation

Table 8-104 Lower Operator Panel installation

1. While holding the Lower OP Panel,

be sure to maintain control of the

three OP Panel cables so that they

come up and over the top of the

Lower OP Panel.

2. NOTE: Edge tips described are

fragile. DO NOT lift or bend the

Lower OP Panel Assembly sharply,

or the edge tips may break.

Slide the left and right Lower OP

Panel edge tips carefully between

the Upper OP Panel

Frame (1 - white) and the Lower OP

Panel Frame (2 - blue).

Begin to slide the Lower OP Panel

into its compartment while making

sure the Trackball Assembly just

clears the Lower OP Panel Frame

Assembly handle.

3. Place the Lower OP Panel into its compartment.

Install the Upper OP Panel/Touch Panel assembly.

Install the eight screws that affix the Lower OP Panel assembly to the Lower OP Panel Frame

Be sure the three shorter screws are installed at the front (see:

Panel (OP) removal" on page

Section 8-6 - Replacing Top Console Parts

Corresponding Graphic

Cables over top of Lower OP Panel

Left edge tip of Lower OP Panel Assembly

Table 8-97 "Lower Operator