Transport Function, Transferable Data - Dräger Cicero EM Instructions For Use Manual

Technical data
Transport function
The transport function permits uninterrupted documenta-
tion even when moving the patient, for example between
bed, pre-op, operating theatre and recovery room.
The haemodynamic parameters are stored in Parameter
Box PB 8800 and transferred between this box and the
connected PM 8060 monitors or the Cicero EM
Anaesthetic Workstation.
The following data can be transferred:
Parameters Settings
ECG
3 or 5-lead cable
Selected lead
Amplitude
Pacemaker identification function on/off
NiBP Function on/off
Automatic on/off
Interval (time)
Cuff inflation pressure
Punction pressure
IBP 1/2 Function on/off
Pressure sensor zero
Pressure sensor sensitivity
Curve amplitude
Absolute/morphological curve display
Catheter position
Interlock with NiBP on/off
SpO Function on/off
2
Mode
C-lock on/off
Interlock with NiBP on/off
Temp. 1/2 Function on/off
160
Measured value for the list Alarm limit
Heart rate
Pulse rate
Systolic pressure
Diastolic pressure
Mean pressure
Systolic pressure
Diastolic pressure
Mean pressure
O saturation
2
Temperature T1 and T2
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit
Upper and lower alarm limit T1