Table of Contents
Advertisement
Preparing for use
Parameter box
Fitting the parameter box
The parameter box can be operated either in the blue
holder or in the slot-in housing. The slot-in housing can
be mounted by Dräger Service on the left-hand side of
the Cicero EM.
The blue holder can be mounted by the user in any
position on a standard rail (10 x 25 mm).
In the blue holder, the parameter box can be tilted up and
down. In the slot-in housing its position is rigidly fixed.
In both cases, the synchronising output for an
external defibrillator is accessible from the rear.
Slot-in housing:
1 Push the parameter box straight into the slot-in
housing. The parameter box locks into position, and
the electrical connections are made.
To remove the parameter box, pull the blue handle on
the box to release the locking lever. The parameter
box can then be simply pulled out of the housing.
Blue holder:
2 Fix the blue holder in a suitable position.
3 Connect the cable of the mounting base to the
connector on the side of the Cicero EM.
4 Hang the parameter box onto the mount from above.
The plug connector must engage.
5 To remove, pull the blue handle on the parameter box.
The parameter box is released and can be taken out
of the blue holder.
6 Defibrillator connection.
Tilting the parameter box:
7 The parameter box can be swivelled up and down.
The parameter box is the central component of the
Dräger transport function. See the separate section in
these Instructions for Use, page 86.
20
D
1
3
2
4
7
E M
e r o
C i c
6
5
Advertisement
Chapters
Table of Contents
