Anaesthetic vaporizer:
Only use the Vapors listed in the list of accessories!
–
Note the separate Instructions for Use of the Vapor.
–
Only use the Vapor intended for each anaesthetic
–
agent!
1 The fill plug must always be inserted and securely
tightened!
2 The thumbwheel must always be set to zero when
there is no fresh gas flow.
3 Vapor must always be secured by means of the
locking lever (set to the left-hand limit).
Connecting external equipment
Connection via the printer interface:
4 with a data cable for printers with serial interface,
such as:
Deskjet (made by Hewlett-Packard)
This connector may also be used as an
RS 232 MEDIBUS interface.
Equipment plugs must be secured with screws!
For interface configuration, see page 64.
Connection via the Dräger RS 232 MEDIBUS interface:
5 with data cable for standard PCs or other monitors.
Equipment plugs must be secured with screws!
For interface configuration, see page 63.
After removing the outer back panel, the following
connections are accessible:
External screen
6 Any S-VGA-compatible screen can be connected.
External O
sensor for inspiratory measurement:
2
7 Connect to the socket marked »O
Airway temperature sensor
8 Connect to the socket marked »Temp«.
«.
2
3
2
0
Vol.
%
5
4
6
Paw
CAN
P-Box
VGA extern
VGA intern
m
P
Preparing for use
Anaesthetic vaporizer
External equipment
1
7 8
*
O
Temp.
/ Spiro
2
19