Local Users - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:
Table of Contents

Advertisement

User authentication

Local users

Local users are authenticated on the device without using an external authentication mechanism such
as TACACS+ or RADIUS. Local user authentication is enabled by default, with one preconfiged default
user.
Default user
At manufacturing time, each Connect IT 16/48 device comes with a default user configured as follows:
Username: admin.
n
Password: The default password is displayed on the label on the bottom of the device.
n
Note
The default password is a unique password for the device, and is the most critical
security feature for the device. If you reset the device to factory defaults, you must log in using
the default user and password, and you should immediately
password. Before deploying or mounting the Connect IT 16/48 device, record the default
password, so you have the information available when you need it even if you cannot physically
access the label on the bottom of the device.
The default admin user is preconfigured with both Admin and Serial access. You can configure the
admin user account to fit with the needs of your environment.
This section contains the following topics:
Change a local user's password
Configure a local user
Delete a local user
Digi Connect IT® 16/48 User Guide
Local users
change the password
to a custom
507
508
515
506

Advertisement

Table of Contents
loading

This manual is also suitable for:

Connect it 48

Table of Contents