Create A Directory - Digi Connect IT 16 User Manual

File system
> ls /etc/config
-rw-r--r--
drw-------
drwxr-xr-x
-rw-r--r--
...
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Create a directory


Command line
This procedure is not available through the WebUI. To make a new directory, use the
specifying the name of the directory.
For example:
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type mkdir /path/dir_name. For example, to create a directory
named temp in /etc/config:
> mkdir /etc/config/temp
>
3. Verify that the directory was created:
> ls /etc/config
...
-rw-r--r--
-rw-------
-rw-r--r--
drwxr-xr-x
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® 16/48 User Guide
1 root root
2 root root
3 root root
1 root root
1 root root
1 root root
1 root root
2 root root
856 Nov 20 20:12 accns.json
160 Sep 23 04:02 analyzer
224 Sep 23 04:02 cc_acl
47 Sep 23 04:02 dhcp.leases
1436 Aug 12 21:36 ssl.crt
3895 Aug 12 21:36 ssl.pem
10 Aug 5 06:41 start
160 Aug 25 17:49 temp
Create a directory
mkdir command,
652