Delete A Custom Firewall Zone - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

2. At the command line, type config to enter configuration mode:

3. At the config prompt, type:

(config)> network interface eth2 zone my_zone

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Delete a custom firewall zone

You cannot delete preconfigured firewall zones. To delete a custom firewall zone:

1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click Firewall > Zones.

4. Click the menu icon (...) next to the appropriate custom firewall zone and select Delete.

5. Click Apply to save the configuration and apply the change.

Digi Connect IT® 16/48 User Guide

Firewall configuration

Connect it 48