Table of Contents
Advertisement
Services
Configure the location service
The location service is enabled by default. You can disable it, or you can enable it if it has been
disabled.
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location.
4. The location service is enabled by default. To disable, or to enable if it has been disabled, click
Enable.
5. For Location update interval, type the amount of time to wait between polling location
sources for new location data. The default is ten seconds.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. For information about configuring Location sources, see the following:
a. To configure a USB GNSS, see
b. To set a static location for the device, see
location.
c. To accept location information from an external location-enabled server, see
device to accept location messages from external
If multiple location sources are enabled at the same time, the device's location will be
determined based on the order that the location sources are listed here.
7. For information about configuring Destination servers, see
remote
host.
8. For information about configuring Geofence, see
9. Click Apply to save the configuration and apply the change.
Digi Connect IT® 16/48 User Guide
Use a dead reckoning external USB GNSS
Configure the device to use a user-defined static
sources.
Forward location information to a
Configure
geofencing.
Location information
receiver.
Configure the
368
Advertisement
Table of Contents
