Configure The Connect It 16/48 Device To Use Custom Factory Default Settings - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

System administration

If your device was manufactured prior to the release of firmware version 19.11.x, the

default user name may be root.

When you first log into the WebUI or the command line, you must change the password for

the admin user. See

c. Reset the default password for the admin account. See

the admin user

Reset the device with the revert command

You can reset the device to the default configuration without removing scripts, keys, and logfiles by

using the revert command:

1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. At the config prompt, enter revert:

(config)> revert

4. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure the Connect IT 16/48 device to use custom factory default

You can configure your Connect IT 16/48 device to use custom factory default settings. This way, when

you erase the device's configuration, the device will reset to your custom configuration rather than to

the original factory defaults.

Required configuration items

Custom factory default file

Digi Connect IT® 16/48 User Guide

Erase device configuration and reset to factory defaults

Change the default password for the admin user

for further information.

for instructions.

Change the default password for

Connect it 48