Table of Contents
Advertisement
Configure Remote Power
Management
Connect the Connect IT to your network
After you have configured the power controller to connect to the network, you should connect the
Connect IT to your network with an Ethernet cable.
1. Connect an
2. Connect the other end of the Ethernet cable to your network.
3. Plug the power controller into a power source.
Connect a 3rd-party device to a serial port on the Connect IT and
then to the power controller
You can complete the connection between the power controller, the Connect IT, and the 3rd-party
device that you want to manage from the Connect IT.
Digi Connect IT® 16/48 User Guide
Configure the Connect IT to connect to a power controller using the
Ethernet cable
to the ETH1 or ETH2 port on the Connect IT.
network
44
Advertisement
Table of Contents
