Update System Firmware; Manage Firmware Updates Using Digi Remote Manager; Certificate Management For Firmware Images; Downgrading - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

System administration

5. Set the location for the device:

192.168.3.1(config)> system location "9350 Excelsior Blvd., Suite 700,

Hopkins, MN"

192.168.3.1(config)>

6. Set the banner for the device. This is displayed when users access terminal services on the

192.168.3.1(config)> system banner "Welcome to the Digi Connect IT 16/48."

192.168.3.1(config)>

7. Save the configuration and apply the change:

192.168.3.1(config)> save

Configuration saved.

192.168.3.1>

8. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Update system firmware

The Connect IT 16/48 operating system firmware images consist of a single file with the following

naming convention:

platform-version.bin

For example, Connect IT 16/48-21.2.39.67.bin.

If you have a network of many devices, you can use Digi Remote Manager Profiles to manage

firmware updates. Profiles ensure all your devices are running the correct firmware version and that

all newly installed devices are updated to that same version. For more information, see the Profiles

section of the

Digi Remote Manager User

The system firmware files are signed to ensure that only Digi-approved firmware load onto the device.

The Connect IT 16/48 device validates the system firmware image as part of the update process and

only successfully updates if the system firmware image can be authenticated.

Downgrading to an earlier release of the firmware may result in the device configuration being

Install firmware from the Digi firmware server

Digi Connect IT® 16/48 User Guide

Update system firmware

Connect it 48